1

So, I’m finally getting to look at this Zcorp Printer that I bought. Had some errors trying to get it to run. Had to clean the rods and replace the print head, but it was running… so I thought. After a few layers ink wasn’t coming out of the head anymore and eventually the machine would get caught in a loop, which would get by the print head trying to print the first spot and then stop, eventually going back to the parking location and then spread more powder. go back to the park location and then try and print the first spot and then spot… over and over.

Looking to see if anyone has had similar issues with a zprinter. Just trying to track down the issue. I looked through the manual and didn’t see anything really pertaining to this.