My DaVinci 1.0 has been printing really weird lately. The layers seem to get out of line. It will print one or two layers, and then the next ones will be an inch further back, and so on and so on. I don’t know if it’s a firmware issue or what. The sliced files look fine. I just re-flashed it from Repetier to the XYZ firmware, but I don’t know if the firmware corresponds with the model. I don’t remember what the version under “Info”>>“System Version” was, but I do know that on the LCD both lowercase and uppercase letters were displayed. I have no idea what is wrong. Any help is appreciated!!!
Sorry it took so long to get back to you. It was the short belt, it needed to be re-tensioned. So I got that fixed. But now it won’t extrude. It will when i press load, but when i go to print it won’t at all. I checked, and there is plenty of space between the extruder and print bed, and sometimes when I pull the filament out, it has this weird notch on it like the gears were slipping. There is no clicking noise, though. I checked the gears, and they seem okay, but I don’t really understand the gear system or bearings on the motor.
