Hi! I posted about this earlier. But it died down. So I’m making a new thread.
Symptoms.
The printer keeps drifting to the left when you print, making for weird slanted prints.
(It’s a gradual slope. Not steps.)
It used to not home properly also. But that managed to be fixed by updating to Sailfish?
What I tried:
- Replaced the Stepper Feed wire and the X-Axis stopper.
- Updated the firmware.
- Tighten the bolts to the belt
- Re-seated and tightened the belts
What I know it’s not.
- Its not the belt.
- Its not the pully.
- Its not the stepper.
- Its not the cable.
- Its not the driver.
I changed all these with others. Or made sure they were fine.
Could it be on the motherboard?
Any suggestions?
