GS101
October 11, 2016, 11:02am
1
Hello all,
I ve been printing for a month or so on my up mini 2, no major issues until then.
As you can see on the two pictures i posted, im having wrapping issues, the item I wish to create doesnt stick to the platform. I have tried using tape for better adherence and sadly that didnt work either.
I have also checked the calibration of my platform and tried passing the heat to 50 for the platform that still didnt helped.
If anyone has a new solution ? I m open to suggestions thank you
GS.
2 Likes
What material, temps speed etc. will be helpful.
If printing PLA, try a bed temperature of 60°C - 70°C; if ABS, try 100°C.
Also add some Gluestick to the bed (spread thinly with a wet towel) or hairspray. This is necessary especially for ABS due to its higher shrink rate.
GS101
October 11, 2016, 8:22pm
4
Up Fila material
Temperature 210 before, now 215
Platform temp 50
Thickness 0.20
Print speed I left the standard one, machine can go from 10 to 100 cm3/h, think standard speed is around 60 if i recall.
Read something about the fact that it may be linked to the filament not cooling down fast enough, and so I could try opening the door and pausing the print at the start for a while.
1 Like
GS101
October 11, 2016, 8:26pm
5
Printed with ABS settings on my PLA for a while had to stop because Nozzle was leaking due to the high temperature but I didnt have such problems at the time and the platform was at 70 so I will try to get it up yes, read some articles about the glue, will try it also.
Thank you
1 Like
As AccuProto said, you have to increase your bed temperature if you are printing ABS. With PLA, wrapping issues is not something that usually happens. You should test your Z-axis calibration, maybe the first layer is too high.
Another solution should be the addition of a skirt, but then you have to remove this part. You can see this on the picture.
I hope this will be helpful to you!
1 Like
