Go to homepage
3D Printing
3D Printing Service
FDM SLA/DLP SLS MJF DMLS/SLM Material Jetting
CNC Machining
CNC Machining Service
CNC Milling CNC Turning Surface Finishing Part Marking
Injection Molding
Sheet Metal Fabrication
Resources
3D Printing Guide CNC Machining Guide Injection Molding Guide Metal 3D Printing Guide Knowledge Base Webinars Help Center
Get instant quote
Sep 2017
1 / 8
Sep 2017
Sep 2017
Impossible
Sep '17

Hello Jesus,

This is taken from P-Class Error List for the uPrint:

Category 14: Controller board aborted causing shutdown

64: Find home failed, Y EOT tripped

67: Head Temperature too high

I would leave the machine shutdown to cool & then re-start. If it happens again you’ll need to speak to a service engineer to check it out.

kind regards

Ian Carter

Impossible Creations

JADCRUISER
Sep '17

Thanks Ian

is kinde of suport side dont heat and material side goes to hi!!

There can be a way to fix some damage connection takein the toggle head out and check for some disconected or unweld part!!!

Is this usual problem?

best

rmigliac
Sep '17

Service guide attached. Error code 14.67 Abort : Head temperature too high

1. Verify the TC and Liquefier Heaters are plugged in properly.
2. Check umbilical is connected properly.
3. TC Amp board is bad. Replace TC Amp Board.
4. Head Board is bad. Replace Head Board.
5. Replace the umbilical cable.
docslide.us_uprint-and-uprint-plus-service-guide.pdf 58 (7.35 MB)

Griffin
Sep '17

This error can occur if you had a major material jam and enough material spooled up into the head to damage the thermocouple.

Alternately the thermocouple can fail or the amplifier board could be the problem.

I think i may may have a spare head for a uPrint. Feel free to message me if you need help working through these errors.

JADCRUISER
Sep '17

Mr Griffin

thanks, yes now I know checking continuity on the connetions that go to the heat, apparently is the support resistor

snd yes , the marerial is jam in al over that

what do I do next

thanks and best regards