For all the simplify users who did’t receive the mail from Simplify, here is there handsome guide to get better prints!
https://www.simplify3d.com/support/print-quality-troubleshooting/ 83
Yes! Thanks for sharing @3Dscaleworks!
I have a MakerGear M2. I am having an issue with initial printing. The printer waits for the bed temperature to get to 70°C and then immediately tries to print the object. It does not wait for the extruder to get to the temperature setpoint.
If you use simpilfy can you share the FFF temperature settings
Is the setting:
Wait for the temperature controller to stabilize before biginning build “on”?
