I’ve just got a new Dreamer. The manual / instructions / stickers all say you MUST check the Voltage before powering up. However, mine does not even have a visible PSU in the bottom! I suspect it now auto sets to the correct voltage but don’t want to blow the dam thing up! I’ve been waiting all day for tech support at Flashforge or TechnologyOutlet (who I bought it from) to get back to me. Anyone else had a similar issue?
This is only to switch between 120 and 240 input voltage. The switch they are referring to should be near or on the plug face where you plug in your cord. It should be preset to 120v input which is the standard household voltage. I’d double check the position of that switch is in the 120v notch and you should be good to go!
Hope that helps!
Hi
i bought from technology outlet also.
there was no switch on mine so I bit the bullet and plugged it in.
it has been fine for over 500 hrs of printing so far.
Cool printer but I have to say the dual extruders are a pain in the ass!
Good luck
You should take that black lid off and switch should be on power supply itself. At least on mine but I have older version…
I took mine apart and there is no switch!
