1

Hello everyone,

I’m getting the error “Sensor error or power not enough!” and I can not figure out what is wrong. I can click all the sensors and they make the 2 beeps. Also this has just started and I was using it for a week and a half prior with out problems. Any help would be appreciated!!

I have a QIDI Tech X-ONE 3D Printer

2

I have a QIDI X-One2 and am getting the same error… it ran beautifully for a bit over a week and now getting this error when the extruder is warming up. It gets to about 100c and gives the “not enough power” error.

Were you able to figure out what was wrong or did your printer require servicing? Thanks!

3

I AM HAVING THE SAME PROBLEM ANY help would be appreciated.