Hi everybody,
I am planning to mount a E3D V6 on my Replicator 2 but I am not completely sure on how to get it done.
I found this on thingiverse:
Is there anybody who could answer my questions (as BlouLapinou) in the comments section?
Any help would be appreciated!
Thanks
2 Likes
Prozix
3
Hi, did you successfully mount the e3d v6 hotend to your makerbot replicator 2?
Sorry, did not catch your message… In fact, I am still looking for a solution… I tested this design without any success:
The aluminium cooling part is impossible to insert into the printed part… perhaps I misunderstood something.
Because I really want to install an e3d on my Rep2, I think I will design something when I have some times.
1 Like
