I printed this file and apparently the bottom right corner of my bed is low, and same with the top right and bottom left a bit. I thought the auto-bed leveling was supposed to account for this. If anyone know why this is, please let me know.
It will to a point. there is another leveling that you do manually. It is in the calibration menu right after mesh level I think where you can enter an offset to help account for low spots. Some also try to shim the bed slightly.
Jump over to the Facebook area (I don’t remember the exact name but can post later) for this printer there is a lot of support there or go to the Prusa forums also!
Alright, I will do that. Thank you.
