Just unboxed and assembled this printer. I have tried autoleveling, and followed the instructions.
1) The Cura software that came with the printer would not installed. So I downloaded the latest version.
2) Autolevel looks like it worked. Was able to adjust the head by setting a new offset (-15.90)
3) Now when I try to test print the sample circle item, the head goes down to the bed and just circle the bed without lifting up. So I am assuming that the ZPos is not either working or not setting properly.
Default Firmware on the board. Now the Mat has this permanent circle on it. And I’m afraid I may have damaged the head. Any suggestions?
