Go to homepage
3D Printing
3D Printing Service
FDM SLA/DLP SLS MJF DMLS/SLM Material Jetting
CNC Machining
CNC Machining Service
CNC Milling CNC Turning Surface Finishing Part Marking
Injection Molding
Sheet Metal Fabrication
Resources
3D Printing Guide CNC Machining Guide Injection Molding Guide Metal 3D Printing Guide Knowledge Base Webinars Help Center
Get instant quote
Jun 2016
1 / 3
Jun 2016
Jun 2016
AutonomousAlex
Jun '16

I have followed the instructions on this page on switching the endstops to see their status and i have determined that my y endstop terminal always reports the endstop being triggered. https://printrbot.zendesk.com/hc/en-us/articles/208275723-Auto-Leveling-Probe-Triggered-vs-Open 1

I have also tried reflashing firmware multiple times and nothing has happened. Please let me know of any additional information you might need.

Cheers,

Alexander’s Hub

  • created

    Jun '16

  • last reply

    Jun '16
  • 2

    replies

  • 1.2k

    views

  • 2

    users

  • 1

    link

ianadan
Jun '16

Hi Alex

If you want support, have you tried opening a ticket on the PB support site? If the cable is broken, it will also report as triggered as they are wired as normally closed.

Check the wiring and the switch with a meter. You may need to get the soldering iron out! :slight_smile:

AutonomousAlex
Jun '16

I made a support ticket at the same time as this thread I just wanted multiple opinions on this matter. I also checked the switch with a multimeter and it is normally closed and does go open when triggered.