Print Orientation

[Suggy]

Looking for some advice on witch way up to print these parts.

Using DesignSparks Mechanical and Simplify3D

I would like to print without supports if possible and wanting to know which way to print the parts.

I have included the parts. What do you recommend?

Bottom Long Left.stl

Bottom Long Left2.stl

Bottom Long Left3.stl

Bottom Long Right.stl

Bottom Long Right2.stl

Bottom Long Right3.stl

Carrage.stl

Carrage2.stl

Carrage3.stl

Top Right.stl

Top Right2.stl

Top.stl

Top2.stl

Top3.stl
Bottom Long Left_0.stl (137 KB)
Bottom Long Left2_0.stl (137 KB)
Bottom Long Left3_0.stl (137 KB)
Bottom Long Right_0.stl (198 KB)
Bottom Long Right2_0.stl (198 KB)
Bottom Long Right3_0.stl (198 KB)
Top Right_0.stl (193 KB)
Top Right2_0.stl (193 KB)

[Suggy]

?

[Robin3D]

Hey @Alex3DHubs, do you maybe have some advice for Suggy?

[MasterFX]

All Version 2, but Version 3 for top. I suggest you close the holes for the screws on Top 3 with only one layer, than you don’t need support

[DmitryR]

Bottom Long Right.stl should print well with .3mm layer height and cooling fan at least at 60% if printing with PLA. No supports should be needed if oriented as shown in attached picture.

Also take a look at this article for more tips:
Top 5 Design Tips for 3D Printing: http://hubs.ly/H0215tC0

[Suggy]

Thanks for the input guys.

Forgot to say it will be ABS

A little confused all 2? even the carrage? as this puts it on its edge

How do you mean close the holes?