I am looking for U.S. hub who has Ninjaflex SemiFlex. SemiFlex is 98 Shore A hardness. It will give just a little bit, but is quite hard. I need someone who can actually print the part at 98. Ninjaflex says it is no problem and has provided me with details.

Any takers?

Thanks,

Brad

1 Like

i think im about 10 months late but i ordered some semiflex today to try out

Let me know if you can print it at 98 shore A. The last part I had printed from this material was only 75 shore A, big difference. To measure the hardness, you can buy a durometer on Amazon for about $50.

i dont have $50 to spend on one of those but if u would like i can mail u a sample print via usps once i get the filament in (friday) and dialed in

JC,

If you want to send me a sample, say a cube .75" then that would be great. Let me know.

i can do that how about a 19mm by 19mm by 10mm calibration cube?

1) It needs to be a cube, I don’t “trust” only 10mm for accuracy in determining hardness.

2) If you agree, are you paying for shipping?

i have no problem paying for shipping.

so u want a 3/4 in square cube?

Yes.

ok, how do i ship it?

How you ship it is up to you. Here is the ship to address:

Brad Evans

2660 Hwy 20, Ste. 610

Bend OR 97701

OK thanks, i don’t get the filament till Friday so it will be Monday or Tuesday before i can ship it out