I have a old CTC printer, board died and I replaced it with a Mightyboard Rev G. with Sailfish 7.5 firmware.
Computer os is win 7 64 bit
Problem is that the only program I can get to manipulate the printer is Replicator G 0040. Matter control can see the printer but cant communicate to it. Cura, AstroPrint, and Makerware(versions 3.4.1 and the most recent version as well) cant even see it.
In looking around some folks have suggested that I used an Arduino board to be the throughput between the printer and my computer. I cant even find any guides or info on this, im at a complete loss. Should I just call it and get a GT2560 board or is project salvageable???
