Looking for Nozzle Calibration Print

Ethan_K · 2016-07-14T01:06:24.000Z

Hello,

On my FlashForge Creator Pro (basically Makerbot Replicator clone), there is an option for nozzle calibration. In there, there’s two numbers which you can set according to a test print. Each one is set at “7” right now. I think I’ve seen this print before, but now I can’t find it. Any help would be appreciated!

Perry_1 · 2016-07-14T18:22:14.000Z

The print is built into Replicator G, which is pretty much abandonware.

However, you can read all about it here: Start on page 52

http://www.sailfishfirmware.com/doc/sailfish.pdf