Looking for Nozzle Calibration Print

[Ethan_K]

Hello,

On my FlashForge Creator Pro (basically Makerbot Replicator clone), there is an option for nozzle calibration. In there, there’s two numbers which you can set according to a test print. Each one is set at “7” right now. I think I’ve seen this print before, but now I can’t find it. Any help would be appreciated!

[Perry_1]

The print is built into Replicator G, which is pretty much abandonware.

However, you can read all about it here: Start on page 52

http://www.sailfishfirmware.com/doc/sailfish.pdf