kilop
1
Hi recently I purchased CTC bizer printer and i need some one more experience with this printer to help me setting this up with Simplify 3D.
I got feeling that my printer is not printing correctly as it should.
first what I done was new firmware upgrade to sailfish 7.7 then ordered spring extruders
then change termistor on hotbuild plate and now tempereature is correct, added print fan and mosfet on control board for PLA,
So if there is some one who have some time and can help me with setting it correctly please conntact me. I’m on SE13 .
Regards Michal
mik111
2
Hi I use one of these with Makerware set up as a Replicator single it works well.
Sra1
3
Hi Michal, sounds like you’re on the right track,
What problems are you seeing, and have you been through Simplify3D’s troubleshooting guide?
I’m near SE13 (but I dont have a CTC)
Chris
Sra1
4
Hi, yes! Sorry for the late reply - would be happy to help figure it out and make a new friend. Lets sort out arrangements offline - let me know contact details
kilop
5
thx for replay Chris
is there any possibility that we can meet and you will take a look on my printer and simplify settings ?
kilop
6
Hi Thx so let me know when you have time xerofuk@gmail.com
