1

Hi there,

I am based in Adelaide and am looking for someone to give me a hand to calibrate my Delta printer. When I first built it I managed to get some ok prints out of it, but pulled it apart to try and rectify some issues with layer height and accuracy, since then I have not been able to get a decent print out of it. I have posted in other forums and have been told its most likely due to effector tilt, but am at a loss to be able to get it rectified.

Payment for you time and knowledge can been in cold hard cash or cold beers - you name it.

For those who are game the printer setup is as follows:

-Robotdigg alloy vertexes

-2020 extrusions

-e3d v6 hot end

-duet pint controller

1 Like