Geeetech 3d one touch probe

[Alexander_Forbe]

i am trying to set up the geeetech probe using the ramps board and i wondered if there was anyone out there that has done this with the ramps 1.4 and if so would they be willing to share there marlin configuration and H pins old man not very good with the programming side ??

[Gfisherwils]

@JackDavies < I believe Jack did something similar

[RippleEphex]

Have you seen this?

There were a few differences with the newer version of marlin, but look through the comments on the video - they tell you what you need to do with the newer version