I just got a new 3D printer and did everything to set it up.
I’ve been trying to print a model that is about 3.5 inches tall and every time I print, it fails.
I watched it closely today and basically when its printing what is supposed to be flat, its not, its ends up raising up and then when the extruder swings back to it, it grabs what was already printed.
It’s very frustrating. I’ve leveled things a couple times in different ways. I Printed with all the doors off/open and closed. Using PLA material.
I’m new to this so I’m out of ideas.
Would LOVE to get this beautiful machine working properly.
