Hello everybody!
I´m new in 3D-printing and recently got a Flashforge Finder. To have levelling problems ist nothing new, however, I couldn’t find my specific problem:
When selecting the Levelling-Button where you have to tighten the three screws and then adjust them, the platform stops about 1cm below the extruder. Like this, it is of course impossible to achieve anythig by using the screws, for the extruder never can touch the platform. When bringing the Z-axis manually up to the extruder, it displays -6. Is there any way to set this value to zero and make the platform go all the way up when levelling? I would appreciate help!
Greetings,
Michael
