This is a paying job and the client is in Melbourne Altona North.
I was contacted in Brisbane from a chap in Melbourne who is after help setting up a Motherboard replacement on a GEN 1 Reprap Prusa Mendel. It’s a MKS GEN V1.4 M/board and needs configuring the firmware to get it operational with a heatbed and LCD/SD card interface.
If someone can do the job for this guy contact me and I will pass on the details.
Antony
Can someone recommend a forum that might have people who could help out these 3d printer users with printer problems?
I can’t do them and they are willing to pay.
Hello!
If you haven’t found someone to help you yet I could probably have a look at it. Otherwise, since it’s a reprap, have a look at the reprap forums. Usually there are quite a lot of people there who have a great amount of knowledge.
Yes that would be great if you could.
Your hub says it’s in Stockholm this job is in Melbourne Australia?
As long as the job only includes software I have found that geographical location isn’t much of a problem. Otherwise I would recommend you to try posting
here RepRap Forums :: Australia, Melbourne RUG
this is the link to a group of 3D printer builders and users in Melbourne, so you will most likely find someone who can help you here.
Otherwise, drop me an email on bo.oscar.svensson(at)gmail.com and I’ll see what I can do for you.
Oscar, The client says he would like to have someone there when it happens… I am assuming so he can “watch over their shoulder” and he has a tone and question.
I joined the repap forum so I will post there but if he can’t get the assistance he needs, I will direct him to you.
Thanks for your help Antony
