Hi does anybody know why when I load an object in the Eagle moss v3 printer software I’m not getting the object on the screen things print well but I can’t see if iv loaded the right file without going to the stl viewer thanks in advance Ade
1 Like
[post deleted per user request]
Hi thanks for the reply can any other software be used with the v3
[post deleted per user request]
I’ve had the same issue in Windows 10. Works in Windows 7 though.
[post deleted per user request]
Indeed. I believe they are looking into it!
Ya they told me the same it’s not very good though considering majority of pc’s are windows 10 now
Indeed again! I luckily have a spare laptop, but not everyone will have.
Fawksey
September 29, 2016, 2:42pm
10
We’re struggling with ours also. Have posted on another thread but will continue.
Buggy Driver in Windows 7 - seams to have a mind of its own.
Couldn’t update the firmware as per instruction in issue Issue 76. Has anybody had any joy with this? May be the route cause of our problems.
Have manages to start the printing process by activating the hood limit switch, but print fails after a few minutes.
E-mail me on chrisholland@eaglemoss.co.uk
I will help you with this issue.
E-mail me on chrisholland@eaglemoss.co.uk
I will help you with this issue.
E-mail me on chrisholland@eaglemoss.co.uk
I will help you with this issue.
E-mail me on chrisholland@eaglemoss.co.uk
I will help you with this issue.
[post deleted per user request]
[post deleted per user request]
[post deleted per user request]
[post deleted per user request]
I have just seen your post
email me at chrisholland@eaglemoss.co.uk
