Hi, I have the newest version of cura. 15.06.02
With the old version I could divide large models by sinking into the printing platform.
I don’t find this in the newest version. Can somebody help me here?
Thanks
3 Likes
Never knew about that Cura feature. I’ve always used MeshMixer to chop up stl objects (plane cut, then separate).
1 Like
Yes I did this now as well. But with the Cura feature you could tell the machine per mm where you want to divide.
i would also like this feature back! was very handy!, I have used it where bottom faces were not quite flat do I sink it into the bed 0.2mm, this gives good flat faces then.
You can do this in slic3r. I did it yesterday.
Thank you all for your help.
Ciao Alfred
