HI, we meet a problem with our printer. (Delta WASP on 2040 turbo)
At the time of the manual leveling, the extrudeur comes to position wich is too low and knocks on the print plate even if the plate is in the lowest position!
The problem seems to be the origin position in Z of the extrudeur.
What are the good values of regulations factories and how to repair this problem?
Thank you very much
Joël D
Hi,
Try to discover if it’s a stepper problem, in order to do that, click “auto home” and then “move axis” “1mm” “z axis” and manualy check if the extruder go down 400 stepps.
Hi Joel, manual leveling must be setted on 1 mm between nozzle and bed. Check wasp site personalfab.it - This website is for sale! - 3d print Resources and Information. 53.
best
Alessandro
make a “autohome” on the display you will see the measure of Z as 441 or 442 then go to “prepare-height change” and decreases the value z. then go to “advanced” and click “save in EEPROM”
Hi ,we change the Z value to 442,it is better,but now we got an other problem,the 0 point during the bedleveling opération,is
lower than the other 3 points (1.2.3).
Is it a problem of bad values of radius and diagonal rod.We got for radius 175.6 and for diagonal rod 294.
do not touch diagonal and radius. Take a sheet of A4 paper and adjusts the three 1,2,3 points outside so that the foil does not touch. then controls the center point 0. it could be that the point 0 is lowest. No problem print a file and see if it works.
Fabrizio
Ok for the manuel leveling with a sheet of paper, and the center point being the lowest still. But i still want to know if the values are correct and if not what are those ? Because i’m pretty sure we did alter them by mistake in “advanced settings.” (especially the Radius one)
So, we checked today, 442 is the right value but we still can find the “restore default settings” in the printers menu. Where is it ?
Thanks to all, for your precious help. Problem solved , it was an unfortunate values changes in “advanced settings”
beside your messages i also received a mail from WASP Support which could turn out usefull for people having the same trouble :
"to change the distance between the extruder and the point zero,you have to decrease the ,zero, value changing
radius: 175,1
diagonal rod: 294,5
practically i change by 0.5mm the two values,i remove 0.5mm from radius and i increase the diagonal rod value with the same value (0.5)
Usualy you can start from 0.3mm and reach 1.0mm like maximum value to find the right leveling values .
After you change the radius and diagonal rod values you have to store memory(advanced-store memory)"
After testing, turns out our values are :
Z Max : 442
Radius : 174.6
Diagonal Rod : 295.0
Thanks again to you all ! Let’s Print !
