Can I get this file printed for me?

[Techpages]

I am a school student, and i need to make a Quadcopter. I have found a suitable frame for it, and I found it quite expensive to print with a shop. Can Anyone who has a printer, print this for me on a little budget (including only the printing cost and shipping) (I don’t have a printer) the file is in thingiverse, pls check the file, find the cost and inform me…

thanks…

link: one from this, FireFlo v2 by SirQuentin - Thingiverse , and four form this, FireFlo v2 Motormounts by SirQuentin - Thingiverse

[Arnoldas]

Hey @Techpages,

If you go over to Online 3D Printing Service | Instant 3D Printing Quotes | Hubs page you can insert those files and see what the approximate prices are

[kissfan4]

where are you located? I can give you a deal on the shipping!!!

[SOC3D]

What’s your zip code?

Build time: 1 hour 7 minutes

Filament length: 3165.3 mm

Plastic weight: 9.52 g (0.02 lb)

Material cost: 0.24

[Evolv3D_Labs]

Do a search for Klacam hub and I can do it in SLS using tough yet flexible Nylon.

$160 for all 5 pcs you just pay the shipping.

[3digitaldesigns]

Hey depending on were you are located I can have all 5 of the needed prints done and shipped by Sunday morning for around $30-40. If you are interested please contact me for further information.

[Techpages]

Is it true for all 5 parts on the same size as in the file? And what is the material cost, usd $? And I am in Sri Lanka , postal code KT 12404, and what’s the final cost for you excluding shipping?

[SOC3D]

I just downloaded the files and plated them using default print settings in PLA. Cost shows as $0.24 USD. Those parts are quite tiny and should be printed at a bit better resolution and fill than defaults which wouldn’t change to much. You should try to find a hub on or near your continent though.