Anycubic i3 Mega Display problem

[Andr45tos]

Good afternoon.

I have an Anycubic i3 Mega but am having an issue.

The touch function on the display that came with it was always causing me issues and I never knew why, as sometimes it wouldnt register my touch. I opened it up and it turns out the ribbon cable is damaged and the wires don’t connect properly.

I’ve tried getting in touch wiht support but to no avail.

Does anybody know where I can find a screen to replace the damaged one? I’ve been searching everywhere and can’t find the same one.

Thank you very much

[foldio1991]

Hi, let me give you this email, they respond fast, well considering time issue mandy@anycubic3d.com

http://www.anycubic3d.com/en/

in products you can find the spare parts. Hope this helps.

[Andr45tos]

Thank you for your swift reply!

I’ve searched their original website, and although they do have LCD panels, they don’t have the TFT panel that my 3d printer came with

I’ll try that email and see if it works.

[Andr45tos]

Still nothing from the Anycubic team. I’m so lot