1

Just built it out of the box. Tried to print and it has been unsuccessful. The printer keeps wanting to go off the bed in many different configurations. sometimes it starts high right off the printer. It has started to print the first layer then gone off the board. I tried setting the parameters to 110 instead of 220 and tried printing the stock gcode box. It printed 3 sides of the box high center, then printed 3 sides of the box to the right of that one, then printed 3 sides of the box to the right of that one, and was about to go off the bed. I am going to try installing sky net to see if there is some bug in the firmware. Any other ideas?