PLA, bed 55, and nozzle 195 degrees. I re-leveled the bed after doing a pre heat to 55 and then successfully printed one of the test prints. Now I am working on dialing in a Profile in Cura the slicer for this printer. When I set up my Monoprice Delta Mini I found start and end gcodes online, but I have not found the same for the HC Maker 7. I may need to search for CR10 settings. Thanks for helping me out. The doing the manual bed leveling with a hot bed was the missing step.
Looks like I am downloading Cura 3.6 next to find the pre setting for the CR10
