I am assembling the A6 and have a problem at attaching the small acrylic part to the fan/nozzle housing with the specified M3 * 10 screws. The screws are tight before the small part is secure.
So the screws are too long or the holes not deep enough!
Also the M3 * 10 screws have countersunk heads but the holes on the small acrylic part are not countersunk!
Has anyone met this and found a solution?
Thanks
Nigel
Have another look through, you’ve probably put the wrong ones in somewhere. :’) or you might need a spacer or something from one?
Thanks for that, but I’m not quite sure what you mean.
I am following the videoed assembly guide, which so far has been faultless and a great help.
It shows the necessary screws for the assembly of this part and I have double and triple checked that I am using that particular screw type. The video does not show any spacer being added.
I have attached here a photo of the problem. Maybe you can look on yours and see how it compares?
Thanks
Nigel
Just found the problem!
Looking at the printed instructions it specifies the M3 * 6 screw for fixing this part!
In fact when I also look forward in the video it specifies the M3 * 10 screw again to fix another part, and there are only two of those screws!
Sorry to bother you.
Nigel
It is done (I think).
Nigel
