Skip to main content
Ive sent a draft to the other 2 guys for comment, I can do the same for you if you wish before i send it. i will need your email address Kevin, if you want to be CC’d in!
I will add that the email mentions this thread but does not address the fact that you guys want a refund too. If you want me to add a paragraph about you wanting a refund too, please let me know and perhaps write it in yourself so i get it right.
Email sent. please comment.
IT looks like you have a lot of the issues I have. One thing I have noticed is the bed mount to the Z Axis is bent by about 4mm.
The only way I could get the calibration done was to adjust the Z Axis to as close to the bed a poss the mess around with the bed adjustment screws which took an age.
Also in the magazine they mention the feeler is 0.2mm, wrong its 0.1 which is the correct distance from the bed.
This is also the same thickness as a sheet of a4 paper.
Very nicely put. The only extra parts that may be added was the fact that initially stated that the collection would be completed in 90 issues which has now been extended and also that there are a growing number looking to be reimbursed. Barry
Check this out guys if you get no joy use some of the parts in conjunction with the kit on here.
and this frame is square I checked it out with a cube
I think we all want a refund to be honest,totally dissatisfied with both the printer and the software.I have just emailed the geeks and told them if they don’t rectify the problem then I want a full refund
I think we all want a refund to be honest,totally dissatisfied with both the printer and the software.I have just emailed the geeks and told them if they don’t rectify the problem then I want a full refund
Hi Jacob,
Please Carbon Copy me in if it will help. I am andygreyrider@googlemail.com
I have just bought an Ormerod 2 secondhand for just under £200.
I have also bought some genuine Arduino kits to go with my Make: Electronics book.
I am going to be building my own style 3D printer and will get a full refund from Eaglemoss via County Court action.
I will keep you updated. As of now, I am getting daily emails from Dbfactory et al Eaglemoss but, I have been advised to ignore them and since I sent my letter of notice to pursue, they will not get another correspondence. At last, I think they are in fear of County Court action.
With a judgement against them, I intend to get my subscription value to ruin their reputation. I think you will be amused that, I am pursuing compensation too.
Kind Regards
Andrew
Fantastic Andrew. Well I wrote a long email last night detailing why I wanted a refund and highlighting the consumer rights act. This is my 2nd attempt at asking for a refund as the first was shoo’d off with a 30 day returns policy. I’m expecting them to repeat their method and ignore my request for a refund. So on that note, if you don’t mind, I would also like to to see you notice to pursue as this will have to be my next step too!. I have sent you an email to the address you have provided. Thank you for your input!