Skip to main content
14 results for@tk0084 #3d-printers
Advanced filters
Relevance
Relevance
Nov '16
-
It's the freewheel in the feeder. It gets gunk built up behind it so you need to remove the c clip, clean the inside of the wheel, clean the shaft it s...
Jan '16
-
I've printed 100's of hours with Xyz PLA. There are multiple reasons it won't load for you. First do you have the proper extruder to print PLA? Older m...
Jul '16
-
I actually have 2 alphas. I had xyz davincis first but recently bought an alpha. After a week of use I decided to sell my davincis and buy a 2nd alpha....
Apr '16
-
I actually have a spare print head for the duo that will print PLA. They're $160 from xyz. I can go cheaper and it's the xyz print head.
Apr '16
-
That video is to remove the extruder. If you're simply trying to clean it then unload the filament, run the cleaning program, use the wire brush to cle...
May '16
-
Is that better than the e3d v6?
Sep '16
-
First you have to get a proper calibration reading since you decided to use the built in calibration. Clean the contact point if all else fails then us...
Jul '16
-
Change your raft layers and density. I usually do 3 raft layers and 45 for the fill. You're trying to save material and doing 1 layer that won't help....
May '16
-
You may not have it in the right spot. Pull up the lever and reposition the extruder so it's closer to the front of the machine. It happened with my du...
Apr '16
-
Have you lubricated the pulley for the filament? What type of filament are you using?
Feb '16
-
I run PLA (hatchbox or xyzprinting) at 198c and the bed at 45c for the first layer then i tell the bed to drop to 20c but it never gets below 32c. If i...
Feb '16
-
Yes but you have to do a lot of customizing and put repetier host firmware on your machine. Google Davinci 1.0 e3d v6 hot end to learn more. Thingivers...
Jan '16
-
Version 2.1.5.9 was a hotfix for advertising. You can download the sheet about the version on their website. I I would highly recommend using simpilify...
Jan '16
-
This could be a model issue. I always run models through an online fixing tool before printing. I've had similar issues and only noticed after studying...