Skip to main content
9 results for@ianadan #3d-printers
Advanced filters
Relevance
Relevance
Dec '17
-
the 1302 didnt have an induction sensor. Do you have a photo of the printer?
Jun '17
-
okay, if you aren't seeing it in Device Manager (or System Report on a Mac), first thing would be to check/change the USB cable. When you try and print...
Jul '16
-
run M503 and check the M212 value for Z. I'd try making it more negative by 0.1 So it if reads M212 Z-0.3 make it M212 Z-0.4 then M500 to save and M501...
Oct '15
-
Hi Calvin It's possible that the set screws in the coupler holding the Z Axis to the motor have started to come lose. This would mean that, occasionall...
Jun '16
-
Hi Alex If you want support, have you tried opening a ticket on the PB support site? If the cable is broken, it will also report as triggered as they a...
May '16
-
Hi Alex What printer is this on? What hot end do you have? Have you tried to reflash the firmware? Ian
Mar '15
-
The bearings should be self lubricating. If you feel they need to be lubricated, then a little light oil or lithium grease, but just a touch - too much...
Dec '15
-
try a layer height of 0.1984mm and check the belt tension. should be firm, but not overtight. Did you build it or was it already assembled?
Jun '15
-
Hi Mark You say this is getting more pronounced over time, so I guess we're looking at a little Wear and Tear here as well as a few other things. I als...