11

stil needed ? or already done ?

greetz KCt

12

hey!

yeah i haven’t managed to have this printed yet but the problem is i would need it by Thursday?

you’re welcome to have a go if this timescale is do-able for you!!

:slight_smile:

13

Hi!

I haven’t managed to have it done yet but did you read Mikes comment below?

He had a go and theres quite a lot of problems with it in terms of needing a lot of support etc & also timescale… if this is okay for you then we can talk!!! :slight_smile:

14

Hi Mike,

Thank you so much for your time and advice!! I really appreciate it :slight_smile:

I’ve had a play with one of those pens before and unfortunately they are extremely tricky/ should be left to the professionals :stuck_out_tongue:

Francesca

15

before i say yes…were is thou home located ?

16

Hey,

I’m in Coventry !

17

oops…i,m located in the netherlands…if id seen it sooner…

but won,t be able to get it there before thursday…

1 Like
18

How about you @Marco_16 @ are you able to help Francesca with her print? Cheers

19

Hi I’m also in Coventry! I’m currently downloading the model and will get back to you if I can print it!

George

20

I’m down near Coventry and most likely could get them printed if they are able to be printed on fdm machines and posted to you by Wednesday/ Thursday.

1 Like
21

That would be brilliant if you could ! did you read the below comments about the correct scaling etc?

Message me if you need more detail/info on the project!

22

Great! How about it, @frankiecheska? George, keep us updated on the 'if’s :wink:

23

I will, sorry my internet is so slow it’s taking ages to download the file. Also by how much can I upscale the design?

George

24

Anything that fits into 45mm3 is fine !

Francesca

25

Mm or cm?!

26

4.5cmx4.5cmx4.5cm

27

Ok I will try one now at 2500% original scale which is slightly over 4.5cm3 but will give us an indication. My gut instinct is that the poles may need to be thicker. I’ll see though.

28

okay, there is leeway with the pole thickness also if that helps.

29

Yes okay that probably would help as there would be less drooping on the overhangs. Also does this have to be finished up to a high standard or is it just a prototype?

30

Its a model for an exhibition so a relatively high standard would be preferred. It depends what you mean by a high standard?