When using the Ultimaker 2 i get this print bed issue which is to do with the temperature sensor, it seems to work when i switch the machine on and off a few times. Sometimes it even happens when i reduce the print bed temperature to 0 when using PLA. I was jsut wondering if anyone had encountered this problem and if so how to fix it, i assume it is probably my fault but not configuring something correctly but still frustrates me to no end. All comments are graciously welcomed!
1 Like
You might also want to keep this guide to troubleshoot your prints.
key23d
3
or contact Ultimaker if you haven’t done that already!
I haven’t had the problem (yet)
Kind regards, Guy
Thanks Guy will check out what @ProdPoint posted and see what the next best step is.
