Start 3D Printing with Eaglemoss V3 Help?

AlexAnipko · 2016-12-04T20:51:56.000Z

Hello Every one.

Have bought 3D printer Eaglemoss. But cant to start something to print.

Green libht button wokking.

But when I press in V3-3D- Create and Print.

But when press button Slice printer doing nothing all stay. No working.

How to start?

I first time with 3D pronting but something or wrong or I dont understand.

Help Please!!!

Thank You

Email-alexanipko@mail.ru

AlexAnipko · 2016-12-04T21:33:57.000Z

initializng printer connection, uploading data to printer. this could take a while

Writing but red line not going up.

Chris_Eaglemoss · 2016-12-05T14:30:57.000Z

Hi I have a couple of questions:-

Have you calibrated the printer and set the height?

Are you using PC/MAC?

AlexAnipko · 2016-12-05T17:57:32.000Z

I use Laptop Window 10

AlexAnipko · 2016-12-05T18:00:46.000Z

Yes. But its no starting. Just I seen one time blue button switched on. But now always green on printer. May be somebody know how reset all and start again??? Thanks

Chris_Eaglemoss · 2016-12-05T23:55:44.000Z

I know this may be a silly question but is the lid up or down when you click print?

Also does the option to print online/offline show?

Chris_Eaglemoss · 2016-12-06T21:47:28.000Z

Does the option for print online/off line show?

Also have you sliced the file first?

AlexAnipko · 2016-12-07T10:42:48.000Z

I online tried and ofline. Sliced pressed to but he doing nothing. May You can send me some file for slicing and print Please. Thank You

Chris_Eaglemoss · 2016-12-07T11:15:33.000Z

Can you go into manual control for the printer

click connect

then test that the nozzel is heating up185 deg, also the print bed 55 deg

Chris

AlexAnipko · 2016-12-07T12:29:44.000Z

Its in setting? Yes I will to try. And what posicion need stay heat table? Just when I move into my room table sliding another place. Or how can reset all? Thank YOU

AlexAnipko · 2016-12-07T12:31:16.000Z

No table stay and all

AlexAnipko · 2016-12-07T12:32:21.000Z

One time been table moving by himself but after start button from front stay blue light not green

Chris_Eaglemoss · 2016-12-07T16:16:17.000Z

All I am doing at the moment is checking that the nozzle and print bed are printing

Also find an stl file for you to print
f-11d_blaster_rifle_starwars.stl (630 KB)

AlexAnipko · 2016-12-07T23:16:21.000Z

Ill try tommorow. If not send you message.

But in which position need to be table heating before I switch on?

Thank You

Chris_Eaglemoss · 2016-12-08T09:35:43.000Z

the table before you switch on should be at the bottom of the printer, it will rise up to the print nozzle when it starts to print.

Start 3D Printing with Eaglemoss V3 Help?

Start 3D Printing with Eaglemoss V3 Help?

created

last reply

replies

views

users

likes

link