Couple of weeks ago, I started to get some trouble with my resin tanks.
The top left corner started to break. This was happening on the same corner of two different tanks. After a bit of googling, I found out this was a bad fabrication of the tank.
On the Formlabs forum I read that Formlabs suggested to contact the support team by email. (support@formlabs.com)
I sent my email with the problem I have.
A couple hours later, a kind lady of the support told me that it was a common problem, and she sent me immediately two new resin tanks. Two days later the new tanks arrived.
I just wanted to let you know, in case you have the same problem.
It’s a poor design on the part of the tanks. I had all 4 of my tanks replaced but the new ones have the same issue. The problem is down to the thin wall on the pouring spout that was designed into the tank. Leave the lid on for a few days and any resin on that area gums up meaning you have to apply more force to get the lid off. Applying this extra force causes the tank to split and pieces to come away. It’s only been a real issue for one tank when the level went ever so slightly up and over and was able to spill out.
Just checked a couple of brand new tanks that arrived the other day. Same design flaw.
Haven’t got around to it. I saw the glass tank thread. I never like to be the first to jump into something new. Would rather wait and see what others experience but if they work well I will be replacing all tanks with glass.
