Hello, I’m looking at upgrading my print surface from the stock buildtak I have. The buildtak seems to really sticks to the print and is a nightmare getting it off, I’ve heard of these “Zebra” beds and was wondering if anyone had experience with them. The other options I have are PEI or just modifying the print settings I have with the buildtak. Any help or suggestions are appreciated! -Quinn
Just so you know, I usually print in PLA but I would like to print a bit of ABS and some other exotic materials
To make sure you know, I more often than not print in PLA however I might want to print a touch of ABS and some other colorful materials…
First thing is not to treat the symptom. If you have adhesion issues, to much or not enough, figure it out!
Depending on the material you may be getting to much squish on the first layer or laying it down to hot.
Most times a new surface is just a different set of issues.
With that said. My personal experience with printinz last fall were dismal. I actually threw them away.
What printer and does it have a heated bed?
I use PEI almost exclusively. On two printers it is on the bed and on a couple others it is on glass.
It has it’s own issues but I have learned them and have consistent results.
I would work on your current setup for a bit before throwing money at it.
What slicer and machine?
Yep, that’s the flexible one, thanks.
