Print Stops after base

puck34696 · 2017-03-02T12:49:52.000Z

I’ve been trying to print the shelf of this item but every time no matter the infill or speed it prints tojust about layer 12 and then it stops extruding and the fil. starts grinding and the prints to mid air. All the drawers and other prints work just fine. Any suggestions ?

thingiverse.com

Small items organizer by cruzher

There is a few component organizers out there already, just thought I would share my version. Hope it helps someones workshop to be a bit more tidy :) EDIT: There is now also a drawer with 8 compartments thanks to Milnei, take a look....

jfield · 2017-03-02T14:23:08.000Z

Temp too low, too much retraction?

wirlybird · 2017-03-02T15:52:40.000Z

Run it through a checker to see that the STL is ok.

puck34696 · 2017-03-02T16:40:52.000Z

I thought the same but it’s the exact same spot on just this stl. I’ve used s3d and cura temp is 200 (pla) and all other prints are good. It gets 95 percent of the base and stops extruding/starts grinding it so never starts on the walls.