SkyTal
1
prints so good afer little bit configuration i think. i use cura and i have one major problem i really think its a simple one and maybe you can help me fix it. it seems that cura doesnt recognize the whole bed of my printer i mean only part of it. when i print something that fits my bed dimensions and in cura it says that its okay so when i position the print to sstand by the nearest edge of the print bed (in cura perspectives) so it prints the print out of the edge and its like leaking out and be out of the bed on that side so what i do i always push the print job at cura to the other side of the bed so it will be good on the other side. the problem is that if i want for example to print a project which takes advantage of my whole bed i cant because i will have nowhere to push it out to the other side and it will leak from the nearest side when it doesnt take any advantage of the other side i am sure it just a matter of configuration and would love to get a little help. thank you so much this forum is awesome
What do you have the x and y limits set to? I use 125 for both on my Mini.
SkyTal
3
where do i check it? and how do i get to it? if i am remember correct i set it up at 120 each when i registered the machine at beginning. and for your mini the cura bed is exactly matched to the actual bed?
It’s under ‘Printers’ and ‘Manage Printers’. (It takes a few clicks.)
I usually keep it at 125 x 125, the (mostly) max dimensions. I’ve take
the Y-axis up to 127 and it seems to work, too.
SkyTal
5
but i dont understand. isnt the printer bed 120 on 120?
Well, no. Take a ruler and measure it. The bed itself is larger than the print area.
