I am using Simplify3D for the laser and for the 3D printer, just for the laser I force the Z axis to the proper focal point and then disable.
Skip to main content
8 days later
1 month later
6 months later
11 days later
1 month later
2 months later
Can you fill me in on the genral settings. I am having issues getting it set up.I am using simplify3d but have been printing with an Anet A8 single extruder, this dual one for somedumb reason has me confounded
Well, I have attached my .fff file here which works for me. You will have to rename the file to .fff and then import it into S3D. Should work though.
bibo_2_touch_laser.pdf 215 (24.5 KB)
19 days later
This printer is amazing. I ordered it on amazon. It gets 5 stars across the board on Amazon’s comment section. The manual and troubleshooting guide are very helpful, and you will get any update on their group chat (only open to users), where you can ask the questions or share your printing experience with other users .
Finally i find ordering BIBO 3D printer on aliexpress will be cheaper. I will make the second purchase on their aliexpress store.
2 months later
It was meant for the scripts, of course you’ll have to change your temp settings. Changing extruder Temps is fairly easy in S3D.
5 months later
I just assembled my BIBO the Heating Bed and Extruders do not heat. I have gone over the assembly instructions but see nothing wrong. any suggestions?
13 days later
Hi, sorry for the trouble. The cause may be the thermistor plug is loose on the motherboard after transportation. Just replug it and the printer will run correctly.
1 month later
Hi everyone, I wanted to purchase a Prusa i3 MK3 but it a three months wait, so I just purchase a Bibo Printer instead, will have it in a week.
I build a lots of RC planes and my use for this printer is to do 3D Plane printing, hope this printer accepted G-code files? Moe
1 month later
Hi,
I own a Bibo
Do you have any specific questions?>