CR-10s Printing Cylinder Problem

Chris01 · 2018-02-25T21:05:15.000Z

I have been trying to get my CR-10 setup and so far I have worked out most of the problems, however I tried to print the famous Benchy model and I found that the chimney on the top did not print properly and there was some slight stringing. I changed the setting and printed it again, this time minimal stringing but the chimney is still not printing correctly.

I made a quick cylinder to test the settings instead of constantly waiting to print a Benchy and I still had the same problem.

Does anyone know how to solve this?

20180225_145719.jpg5312×2988 3.82 MB

20180225_145558.jpg5312×2988 3.92 MB

peterpiper · 2018-09-09T13:12:07.563Z

Hello Chris,
Did you ever figure this out. I am having the same problem.
Peter