The Printer is showing on Com 4 , Its the only available choice in the cura drop down menu. I did check and change the baud rate yesterday. Still no connection. I guess until I figure it out I will use the Micro sd. The second problem like I mentioned is No Other filament but the test print stuff has worked, I had some promising results with the wood PLA stuff I purchased but I think the bed needs leveled again. I am not ignorant to technology I taught myself to build my last PC so I know I can do this lol.
Skip to main content
I’m not connected directly to my PC, but on the Wanhao i3 I would recommend buying a Raspberry Pi and install OctoPrint. Then you will be able to access the printer from not only this PC, but also other PC´s in the network. And online if you open your router for it.
There is also a lot of information at http://3dprinterwiki.info 260 for those that haven’t found that yet and the FB page.
Yes it’s the jumper. It’s labeled on the board as J14 or Auto Reset. Here is a picture to help as well.
5 months later
Was really hesitant to open up the i3, but I bit the bullet and she’s working away. Many thanks.
2 years later
Hi Scott,
I still cannot get my printer to connect to my computer on Windows 10. Did you find the answer?
