Here are some screenshots. The model of the OK hand came out perfectly that came in the sd
card for the duplicator i3 plus.
Every time i try to put on a model from cura it seems to never fill in the horizontal layers.
Can someone help me.
Classic under- extrusion. What are your extrusion settings - what material are you printing with?
1 Like
Screen dump of Cura will be helpful
Looks like under extrusion. Could be too low temperature or just not the right flow rate settings.
Titjer
5
Hello.
I think your extruder temp is too low. What kind of product are you extruding ?
Maybe, reduce also the printing speed. 50mm/s gives good results.
