So the black mesh that groups all the wires together and is connected to the extruder rubs against the back left corner of my build platform has anyone else had this problem? also if someone else who owns a dremel could send me a picture of the inside of there machine so I can see if my cable grouping is hanging stangely.
A picture with the head over to the one side. I do find that the filament can cause issues when printing at the back pf the build surface (by the dremel logo). I try to keep my prints forward a bit or if I am printing near the back center I watch the print a bit more closely.
How tight to the extruder is your cable bundle? I have almost no wiggle room with the cables, to the point of making it difficult to unplug them. I am not near my printer at the moment but I will try to take a closer look at it (if I recall correctly the last time I was unplugging stuff it almost felt like it was connected to a bracket). If there isn’t a small bracket that this bundle is ziptied to it shouldn’t be too tricky to print one. Same with the other end of the cable it basically doesn’t move when printing so you should be able to ziptie it to one of the Z-axis components to keep it high. All these cables are above the Y-carriage try posting a picture of what is happening with yours and someone here might see something out of place.
