alexgal
1
Hi everyone,
We had some issues (warping mostly) printing reliably ABS in production with blue tape, hairspary, etc.
Unfortunately, none of these methods were consistent. Buildtak worked for a few prints, but it is pain to remove and replace and recalibrate the bed.
We developed a cheap, non-toxic power that is mixed with water and applied with a brush to the bed.
The adhesion is perfect, once it cools down you can easily remove the piece. For pieces having a height smaller than 3", we don’t even use enclosures and we print reliably.
If you are interested, check out the https://www.dustnprint.com/blog/printing-the-warpinator5000
and https://www.dustnprint.com/blog/dustnprint-getting-started
If anyone is interested, I have 3 samples that I can give out.
Thank you,
Alex
alexgal
2
Awesome, all samples gone!
I must admit, this dustnprint works wonders.
