Hi, I have printed a lot marvins today. This is my best one. Everything looks good except the ring on his head… Will i pass the review with this one? I used cura slicer. I have a geeetech i3 pro b acrylic. 60 for speed 195 c extruder temp 60 c bed temp 200 microns PLA 1.75 mm
I would say no, that marvin looks terrible. How would you feel if you paid for an order and the print looked like that.
9 Likes
Should reduce the heat, the filament is not cooling enough between each layer. Try turning off the bed heater, PLA does not need a heated bed. Make sure the filament fan is running at 100% after the first layer.
Speed is way to fast. Try around 1200mm/min. Extruder temp isn’t to bad but could be lowered a little if the filament will extrude ok.
Bed could go lower to 55.
Make sure the part cooling fan is on full after the first layer.
Try printing 4 at a time to see if it improves things at all.
Hi everyone, I printed two parts of marvin and they look a lot better now.
2 Likes
Much better, should be good to go. What print settings did you go with
I’d suggest dropping the speed down to 20mm / second.
Hi, I used same settings. The only difference is that i dropped the speed on the top to 25 and that i printed 2 of them.
